Wagoneer L6-242 4.0L VIN M FI (1988)
15.
Check and adjust front and rear bands if necessary.
16.
Connect valve body overdrive and converter clutch solenoid wires to case connector.
17.
Install oil pan and new gasket. Tighten pan bolts to 17 Nm (13 ft. lbs.) torque.
18.
Lower vehicle and fill transmission with Mopar ATF Plus, type 7176 fluid.
19.
Check and adjust gearshift and throttle valve cables if necessary
Removal
VALVE BODY REMOVAL
1.
Shift transmission into Neutral.
2.
Raise vehicle.
3.
Remove gearshift and throttle levers from shaft of valve body manual lever.
4.
Disconnect wires at park/neutral position switch.
5.
Disconnect wires at park/neutral position switch and solenoid case connector.
6.
Position drain pan under transmission oil pan.
7.
Remove transmission oil pan and gasket.
8.
Remove fluid filter from valve body.
9.
Remove bolts attaching valve body to transmission case.
10.
Lower valve body enough to remove accumulator piston and springs.
11.
Work manual lever shaft and electrical connector out of transmission case. Then lower valve body, rotate it away from case, pull park rod out of
sprag and remove valve body.