Wagoneer L6-258 4.2L VIN C 2-bbl (1982)
13.
Adjust the Sole-Vac throttle positioner (M) to obtain the specified engine rpm. Refer to the Vehicle Emission Control Information label.
14.
Turn the ignition switch OFF.
15.
Remove the jumper wire from the Sole-Vac holding solenoid wire connector (if connected).
16.
Connect the Sole-Vac holding solenoid wire connector.
17.
Remove the plug and connect the vacuum hose to the vacuum actuator.
18.
Disconnect the tachometer.
19.
If disconnected, connect the A/C compressor clutch wire connector.
20.
Install the air filter assembly.
21.
Road test the vehicle.
SRT/TIC INFORMATION
OPERATION DESCRIPTION
NUMBER
TIME
TIC
CO. IDLE SPEED, ENGINE-ADJUST
0106
0.6
1-265
INC. IGNITION TIMING, FAST IDLE, CURB IDLE AND SOLE-VAC THROTTLE POSITIONER ADJUSTMENTS
FILING INSTRUCTIONS
Record this I.S. Note on page B-38 of the M.R. 253 manual and file it in the manual.