Wagoneer L6-258 4.2L VIN C 2-bbl (1982)
7.
Apply a direct source of 34-51 kPa (10-15 in. Hg) vacuum to the vacuum actuator (K). Use Hand Operated Vacuum Pump Tool J-23738-A, or
equivalent.
8.
Increase the engine speed to above 1200 rpm for 3 to 5 seconds and allow the engine to return to curb idle speed.
9.
With the Sole-Vac throttle positioner fully extended, turn the vacuum actuator adjustment screw (L) on the throttle lever until the specified engine
rpm is obtained. Refer to the Vehicle Emission Control Information label.
10.
Disconnect the vacuum source from the vacuum actuator.
11.
With a jumper wire, apply battery voltage (12V) (or connect the holding solenoid wire connector and turn ON the air conditioner with the
compressor clutch wire connector disconnected) to energize the holding solenoid.
12.
Hold the throttle open manually to allow the throttle positioner to fully extend.
NOTE:
Without the vacuum actuator, the throttle must be opened manually to allow the Sol-Vac throttle positioner to be fully extended.
