Wagoneer L6-258 4.2L VIN C 2-bbl (1982)
9. Lubricate outside diameter and chamfer of pressure plate with vaseline to insure against damage to O-ring seals in housing. Then install pressure
plate in housing over dowel pins.Ported face of pressure plate goes toward pump ring.
10. Using a 23/4 inch diameter sleeve to apply pressure to outer edge of pressure plate only, press pressure plate into seat. Pressure plate will
travel about 1/16 inch to seat. Do not press or hammer on center of pressure plate as to do so will cause permanent distortion resulting in
pump failure.
11. Install two pressure plate springs, one over each dowel pin in pump housing.
Fig. 10 Installing end plate & retaining ring
Fig. 11 Installing flow control valve & spring
Fig. 12 Installing pressure union O-ring seal
12. Lubricate outside diameter and chamfer of end plate with vaseline to insure against damage to O-ring seal in housing. Then press end plate into
housing. While holding end plate down in housing, install end plate retaining ring. Be sure end plate is completely and solidly seated in groove of
housing.
13. Remove assembly from press and place on work bench. Install flow control spring and valve in bore of housing. Make sure hex head screw goes
into housing bore.