Wagoneer L6-258 4.2L VIN C 2-bbl (1982)
Fig. 15 Spool valve assembly. Model 605
Fig. 21 Stub shaft installation. Model 605
1. To assemble spool valve proceed as follows:
a. Install three teflon & three O-ring seals on spool.
b. Lubricate spool with power steering fluid, then rotate spool while installing.
c. Install stub shaft into valve body.Notch must fully engage pin and cap must seat against shoulder.
2. Assemble worm shaft on valve. Install snap ring with "curved-in end" on same side as access hole.
Fig. 13 Valve & worm removed from rack.Model 605
Fig. 22 Installing valve & worm into rack.Model 605