Wagoneer L6-258 4.2L VIN C 2-bbl (1982)
Clutch Master Cylinder: Service and Repair
1. Disconnect hydraulic line at clutch cylinder.
2. Cap hydraulic line and master cylinder opening to prevent entry of dirt.
3. Remove cotter pin and washer retaining cylinder pushrod on clutch pedal and slide rod off pedal pivot.
4. Remove nuts attaching clutch cylinder to firewall and remove cylinder. When servicing the clutch master cylinder, inspect the cylinder bore for
nicks, scratches and scoring, corrosion, pitting or roughness, cracks, porosity and excessive wear. Do not attempt to repair a damaged master
cylinder by honing, and replace the master cylinder if the bore is damaged in any way. While slight discoloration of the cylinder bore is
acceptable, the master cylinder can only be overhauled (resealed) if the bore is clean and smooth.
5. Reverse procedure to install. Torque cylinder attaching nuts to 11 ft. lbs.
