Wagoneer L6-258 4.2L VIN C 2-bbl (1982)
3.
Apply Mopar Silicone Windshield and Glass Sealer into leak source. Remove excess sealant.
4.
The sealer cures in about one hour. High humidity will speed the cure. Care should be taken not to apply excess material as it may flow into
unwanted areas. Application of a second dressing is suggested for large gaps.
5.
Test for leaks after the sealer has cured for about one hour. Reapply if necessary. The sealer will fully cure in about 24 hours.
SUGGESTED APPLICATIONS FOR MOPAR SILICONE WINDSHIELD AND GLASS SEALER
Windshields**
Windows
Headlamp Assemblies
Sunroofs
Backlights
Sealing Air Leaks Between Weatherstrips and Mounting Surfaces
**Mopar Silicone Windshield and Glass Sealer is NOT to be used in place of Urethane adhesive which is required for windshield and glass installation.
It is to be used as a leak sealant only.
DO NOT USE Mopar Silicone Windshield and Glass Sealer for gasketing of engine, transmission, and rear axle components. It is not intended nor will it
work for this use.
Policy:
Information only
