Wrangler L4-150 2.5L VIN E TBI (1990)
Window Regulator: Service and Repair
REMOVAL
1. Remove trim panel and water shield.
2. Lower glass to expose guide channel fasteners. Remove fasteners and guide channel. Raise window to full up position and apply masking tape to
glass and over top of window frame.
3. Remove division channel lower adjusting screw.
4. Remove regulator attaching screws. Push division channel outward and remove regulator through access hole in inner door panel.
INSTALLATION
1. Position regulator in door and install attaching screws.
2. Remove masking tape from glass and lower glass.
3. Slide guide channel onto regulator arm and position channel on glass. Install attaching screws.
4. Install division channel lower adjusting screw.
5. Check operation.
6. Install water shield and door trim panel.