Wrangler L4-2.4L VIN 1 (2006)
Parking Brake Cable: Service and Repair
Drum
REMOVAL- DRUM BRAKES
1. Raise vehicle and loosen equalizer nuts until rear cables are slack.
2. Disengage cable from equalizer and remove cable.
Fig. 39
3. Remove cable bracket from upper suspension arm.
4. Remove rear wheel and brake drum.
5. Remove secondary brake shoe and disconnect cable from lever on brake shoe.
6. Compress cable retainer with worm drive hose clamp and remove cable from backing plate.
INSTALLATION - DRUM BRAKES
1. Install new cable in backing plate. Be sure cable retainer is seated.
2. Attach cable to lever on brake shoe and install brake shoe on backing plate.
3. Adjust brake shoes to drum with brake gauge.
4. Install brake drum and wheel.
5. Install cable/bracket on upper suspension arm.
6. Engage cable in equalizer and install equalizer nuts.
