Wrangler L4-2.4L VIN 1 (2006)
17.
Slide shrink tube over soldered splices and shrink with a heat gun until sealant is visible on both ends of the splice (Fig. 4).
18.
Install the cover on the bottom of the PDC.
19.
Install the PDC to its bracket.
20.
Install the positive battery cable to the PDC. Tighten both attaching nuts to 11.3 Nm (100 in. lbs.).
21.
Install the positive and negative battery cables from the battery.
22.
Set the clock to the correct time.
23.
After the Repair Procedure is completed, the vehicle will need to be driven to update the OBD system. It may require several days of normal drive
cycles to update all of the required OBD monitors.
a.
The vehicle is ready for I/M emissions testing when the Malfunction Indicator Lamp (MIL) remains illuminated continuously after turning
the ignition key to the ON position without cranking the engine.
b.
The vehicle is NOT ready for I/M emissions testing, when the MIL flashes for 10 seconds approximately 15 seconds after turning the key to
the ON position (without cranking the engine) and then returns to continuous illumination. The vehicle will require further drive cycles. If
this condition persists after several days of further drive cycles, then additional diagnosis may be required.
POLICY:
Reimbursable within the provisions of the warranty.