Wrangler L4-2.4L VIN 1 (2006)
Suspension Spring ( Coil / Leaf ): Service and Repair
Rear
SPRING
REMOVAL
1. Raise and support the vehicle. Position a hydraulic jack under the axle to support it.
2. Disconnect the stabilizer bar links and shock absorbers from the axle brackets.
3. Disconnect the track bar from the frame rail bracket.
4. Lower the axle until the spring is free from the upper mount seat and remove the spring.
INSTALLATION
NOTE: Springs can be installed with either end up.
1. Position the coil spring on the axle pad isolator.
2. Raise the axle into position until the spring seats on the upper isolator.
3. Connect the stabilizer bar links and shock absorbers to the axle bracket. Connect the track bar to the frame rail bracket.
4. Remove the supports and lower the vehicle.
5. Tighten the stabilizer bar links, shock absorbers and track bar to specified torque.