Wrangler L4-2.5L VIN P (1999)
PDC Mounting Bracket Remove/Install
10. Remove the three screws that secure the PDC mounting bracket to the right front inner fender.
11. Remove the PDC mounting bracket from the right front inner fender.
INSTALLATION
NOTE: If the PDC is being replaced with a new unit, be certain to transfer each of the fuses and relays from the old PDC to the proper cavities of the
new PDC.
1. Position the PDC mounting bracket onto the right front inner fender.
2. Install and tighten the three screws that secure the PDC mounting bracket to the right front inner fender. Tighten the screws to 3.9 Nm (35 in. lbs.)
.
3. Position the PDC and the dash wire harness unit in the engine compartment.
4. Engage the mounting slots on the PDC housing with the stanchions of the PDC mounting bracket and push the unit downward until the mounting
bracket latches engage the mounting tabs on the PDC housing.
5. Install the eyelets of the battery positive cable take out and the engine wire harness take out onto the PDC stud.
6. Install and tighten the nut that secures the eyelet of the battery positive cable take out and the engine wire harness take out onto the PDC stud.
Tighten the nut to 8.4 Nm (75 in. lbs.).
7. Engage the tabs on the lower edge of the terminal stud cover in the slots on the back of the PDC housing, then engage the latch on the top of the
cover with the latch tabs on the PDC housing.
8. Engage each of the retainers that secure the dash wire harness to the vehicle body and chassis components.
9. Install all of the fasteners that secure each of the dash wire harness ground eyelets to the vehicle body and chassis components.
10. Reconnect each of the dash wire harness connectors.
11. Reconnect the battery negative cable.