Wrangler L4-2.5L VIN P (1999)
Transmission Position Switch/Sensor: Service and Repair
REMOVAL
1. Raise vehicle and position drain pan under switch.
2. Disconnect switch wires.
3. Remove switch from case.
INSTALLATION
Fig 24. Park/Neutral Position Switch
1. Move shift lever to Park and Neutral positions. Verify that switch operating lever fingers are centeredin swithch opening in case.
2. Install new seal on switch and install switch in case. Tighten switch to 34 N-m (25 ft. lbs.) torque.
3. Test continuity of new switch with 12V test lamp.
4. Connect switch wires and lower vehicle.
5. Top off transmission fluid level.