Wrangler L6-4.0L VIN S (2000)
7. Unplug the three wire harness connectors from the back of the heater-A/C control.
8. Remove the heater-A/C control from the instrument panel.
INSTALLATION
1. Plug the three wire harness connectors into the back of the heater-A/C control.
2. Position the heater-A/C control in the instrument panel and secure it with four screws. Tighten the screws to 2.2 Nm (20 in. lbs.).
3. Reach through the instrument panel glove box opening to reconnect the two halves of the heater-A/C vacuum harness connector.
4. Reinstall the glove box in the instrument panel.
5. Reinstall the center bezel onto the instrument panel.
6. Connect the battery negative cable.