Wrangler L6-4.0L VIN S (2000)
Water Shield Upper Screws Remove/Install
6. Remove the two screws that secure the multi-function switch water shield and bracket to the top of the steering column.
Water Shield Lower Screw Remove/Install
7. Remove the one screw located below the multi-function switch control stalk that secures the multi-function switch water shield and bracket to the
steering column.
8. Gently pull the lower mounting tab of the multi-function switch water shield bracket away from the steering column far enough to clear the screw
boss below the multi-function switch control stalk.
9. Lift the water shield and bracket with the multi-function switch off of the left side of the steering column far enough to access the two
multi-function switch wire harness connectors. If the vehicle is equipped with the optional tilt steering column, lifting gently upward on the tilt
release lever will provide additional clearance to ease multi-function switch removal.
10. Disconnect the two instrument panel wire harness connectors from the multi-function switch connector receptacles.
11. Remove the multi-function switch and water shield from the steering column as a unit.
12. Gently and carefully remove the water shield from the switch by pulling it over the hazard warning switch button and the multi-function switch
control stalk.
INSTALLATION
1. Gently and carefully install the water shield onto the switch by pulling it over the hazard warning switch button and the multi-function switch
control stalk.
2. Position the multi-function switch and water shield near its mounts on the steering column as a unit.
3. Reconnect the two instrument panel wire harness connectors to the multi-function switch connector receptacles.
