Wrangler L6-4.0L VIN S (2000)
Fuel Rall Mounting
13. Remove fuel rail mounting nuts/bolts.
14. Remove fuel rail by gently rocking until all the fuel injectors are out of intake manifold.
INSTALLATION
1. Clean each injector bore at intake manifold.
2. Apply a small amount of clean engine oil to each injector o-ring. This will aid in installation.
3. Position tips of all fuel injectors into the corresponding injector bore in intake manifold. Seat injectors into manifold.
4. Install and tighten fuel rail mounting bolts to 11 ± 3 N.m (100 ± 25 in. lbs.) torque.
5. If equipped, connect wiring harnesses to injection rail studs.
6. Connect electrical connectors at all fuel injectors. To install connector. Push connector onto injector (1) and then push and lock red colored slider
(2). Verify connector is locked to injector by lightly tugging on connector.
7. Connect fuel line and fuel line latch clip to fuel rail. Refer Quick-Connect Fittings.
8. Install protective cap to pressure test port fitting (if equipped).
9. Install cable routing bracket to intake manifold.
10. Connect throttle cable at throttle body.
11. Connect speed control cable at throttle body (if equipped).
12. Connect automatic transmission cable at throttle body (if equipped).
13. Install air tube (or duct) at top of throttle body.
14. Install fuel tank cap.
15. Connect negative battery cable to battery.
16. Start engine and check for fuel leaks.
