Wrangler L6-4.0L VIN S (2000)
Body Control Module: Vehicle Damage Warnings
Before disconnecting any control module, make sure the ignition is "off". Failure to do so could damage the module.
When testing voltage or continuity at any control module, use the terminal side (not the wire end) of the connector. Do not probe a wire through the
insulation; this will damage it and eventually cause it to fail because of corrosion.
Be careful when performing electrical tests so as to prevent accidental shorting of terminals. Such mistakes can damage fuses or components. Also, a
second code could be set, making diagnosis of the original problem more difficult.
When replacing a blown fuse, it is important to use only a fuse having the correct amperage rating. The use of a fuse with a rating other than indicated
may result in a dangerous electrical system overload. If a properly rated fuse continues to blow, it indicates a problem in the circuit that must be
corrected.
Service and general information labels about the airbag system can be found on the driver's sun visor, the glove box door, and in the engine
compartment.
To ensure that the airbag will be ready to deploy in a collision, have the system serviced by an authorized dealer.
