Wrangler L6-4.0L VIN S (2000)
6. Disconnect the cross-body wire harness connector from the ACM. To disconnect the cross-body wire hareness connector from the ACM:
a. Pull the two white locks out about 3 millimeters (0.125 in.) from each side of the connector.
b. Squeeze the two connector latch tabs between the thumb and forefinger and pull the connector straight away from the ACM connector
receptacle.
7. Remove the ACM and mounting bracket from the floor panel transmission tunnel as a unit.
INSTALLATION
1. Reconnect the cross-body wire harness connector to the ACM connector receptacle. Be certain that the connector latches are fully engaged and
that the white connector locks are pushed in.
2. Carefully position the ACM and mounting bracket unit to the floor panel transmission tunnel. When the ACM is correctly positioned the arrow on
the ACM label will be pointed forward in the vehicle.
3. Install and tighten the four screws that secure the ACM mounting bracket to the floor panel transmission tunnel. Tighten the screws to 10.7 Nm
(95 in. lbs.).
4. If the vehicle is equipped with the optional ABS brakes, install the acceleration switch and mounting bracket onto the floor panel transmission
tunnel.
5. Do not reconnect the battery negative cable at this time. Refer to Airbag System/System Diagnosis/Verification Tests for the proper procedures.