Wrangler L6-4.0L VIN S (2000)
2. Remove the center bezel from the instrument panel.
Accessory Switch Bezel Remove/Install
3. Remove the four screws that secure the accessory switch bezel to the instrument panel.
4. Pull the accessory switch bezel out from the instrument panel far enough to access the wire harness connectors.
5. Unplug the wire harness connectors from the rear of the accessory switches and the cigar lighter.
6. Remove the accessory switch bezel from the instrument panel.
7. With a small thin-bladed screwdriver, gently pry the snap clips at the top and bottom of the rear wiper and washer switch receptacle on the
back of the accessory switch bezel and pull the switch out of the bezel.
8. Reverse the removal procedures to install. Be certain that both of the switch snap clip retainers in the receptacle on the back of the accessory
switch bezel are fully engaged. Tighten the mounting screws to 2.2 Nm (20 in. lbs.).
