Wrangler L6-4.0L VIN S (2000)
INSTALLATION
1. Position generator to engine and snap field wire connector into rear of generator.
2. Install B+ terminal to generator mounting stud. Tighten mounting nut to 8.5 Nm (75 in. lbs.) torque.
3. If equipped, snap plastic cover to B+ terminal.
4. Install generator mounting fasteners and tighten as follows:
-
Generator mounting bolt - 55 Nm (41 ft. lbs.) torque.
-
Generator pivot bolt/nut - 55 Nm (41 ft. lbs.) torque.
CAUTION:
-
Never force a belt over a pulley rim using a screwdriver. The synthetic fiber of the belt can be damaged.
-
When installing a serpentine accessory drive belt, the belt MUST be routed correctly. The water pump will be rotating in the wrong direction if
the belt is installed incorrectly, causing the engine to overheat.
5. Install generator drive belt.
6. Install negative battery cable to battery.