Wrangler L6-4.0L VIN S (2000)
Fig. 13
7. Remove spool valve O-ring and valve body teflon rings and O-rings underneath the teflon rings.
8. Remove the O-ring between the worm shaft and the stub shaft.
ASSEMBLY
NOTE: Clean and dry all components, then lubricate with power steering fluid.
1. Install spool valve spool O-ring.
2. Install spool valve in valve body by pushing and rotating. Hole in spool valve for stub shaft pin must be accessible from opposite end of valve
body.
Fig. 14
3. Install stub shaft in valve spool and engage locating pin on stub shaft into spool valve hole.