Wrangler L6-4.0L VIN S (2000)
Pinion Gear: Service and Repair
Front Axle - 181FBI
The ring gear and pinion are serviced as a matched set. Do not replace the pinion without replacing the ring gear.
REMOVAL
1. Remove differential assembly from axle housing.
2. Mark pinion yoke and propeller shaft for installation alignment.
3. Disconnect propeller shaft from pinion yoke. Using suitable wire, tie propeller shaft to underbody.
Fig. 34
4. Using Holder 6958 to the hold yoke, remove the pinion nut and washer (Fig. 34).
Fig. 35
5. Using Remover C-452 and Holder C-3281, remove the pinion yoke from pinion shaft (Fig. 35).