Wrangler L6-4.0L VIN S (2000)
Shifter Transfer Case: Service and Repair
REMOVAL
1. Shift transfer case into 4L.
2. Raise vehicle.
Fig. 4
3. Loosen adjusting trunnion locknut and slide shift rod out of trunnion (Fig. 4). If rod lacks enough travel to come out of trunnion, push trunnion out
of torque shaft.
4. Lower vehicle.
5. Remove console.
6. Remove screws attaching lever assembly to floor pan and remove assembly and shift rod (if left attached).
INSTALLATION
1. If shift rod was not removed from lever assembly, work rod down through floor pan opening. Then position lever assembly on floor pan and install
assembly attaching screws
2. Install console.
3. Raise vehicle.
4. Connect trunnion to torque shaft arm. Or, slide shift rod into trunnion on range lever. Be sure shift rod slides freely in trunnion.
5. Verify that range lever is in 4L position. Then tighten trunnion lock bolt.
6. Lower vehicle and check transfer case shift operation.