Wrangler 2WD V6-3.8L (2008)
Cruise Control Switch: Service and Repair
Removal
REMOVAL
Mounting hole (1) uses a screw. Depending on model line, mounting holes (2) may use either two screws, or one screw and a locating pin.
WARNING:
-
Do not place a non-deployed airbag face down on a hard surface as the airbag will propel into the air if accidentally deployed, and could
result in serious or fatal injury.
-
Disconnect and isolate the battery negative (ground) cable before beginning steering wheel removal or installation. This will disable the
front airbag system. Failure to disconnect the battery could result in accidental front airbag module deployment and possible personal
injury.
-
Allow the front airbag system capacitor to discharge for two minutes before removing the steering wheel or any front airbag system
component.
The speed control switch is mounted in the steering wheel and wired through the clock spring device under the airbag module.
1. Adjust steering wheel until tires are in STRAIGHT-AHEAD position.
2. Remove negative battery cable.
3. Turn off ignition.
4. Remove air bag.
5. Disconnect connector from clockspring.
6. Remove three mounting fasteners.
7. Remove horn switch.
