Wrangler 2WD V6-3.8L (2008)
3. Reconnect the body wire harness (3) and instrument panel wire harness (4) connectors (2) to the ORC connector receptacles located on the right
side of the module (1). Be certain that the latches on the connectors are each fully engaged.
4. Reinstall the center console onto the top of the floor panel transmission tunnel. See: Body and Frame/Interior Moulding / Trim/Console/Service
and Repair/Center Console - Installation.
5. Do not reconnect the battery negative cable at this time. The Supplemental Restraint System (SRS) verification test procedure should be performed
following service of any SRS component. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic
Trouble Code Tests and Associated Procedures/Verification Tests.