Wrangler 2WD V6-3.8L (2008)
5. Measure from end of Tie rod Tube 502.4mm (19-3/4in) and place a locating mark on the Tie rod Tube at number 2 as shown in (Fig. 3).
6. Align left edge of Damper Bracket on locating mark from as shown in (Fig. 4) Bracket Bolt threads should be pointing forward with bolt parallel to
the ground.
7. Torque Damper Bracket nut to 50Nm (37ft.lbs), Refer to (Fig. 4) number 3.
8. Install steering damper to axle bracket and steering damper bracket with dust shield of steering damper at the tie rod steering damper bracket (Fig. 4).
a. Install the steering damper bolt in the axle bracket and tighten nut to 68 N.m (50 ft.lbs.) (Fig. 4) number 1.
