Wrangler 2WD V6-3.8L (2008)
Axle Beam: Service and Repair
Removal
Axle Bushing
AXLE BUSHING
1. Remove the upper suspension arm from axle See: Control Arm/Service and Repair/Front Upper Control Arm - Removal.
2. Install the special tool 9948-3 Nut (1), 9948-1 Receiver (2) and 9948-2 Driver (4).
3. Press the bushing out of the axle housing.
Axle Bracket Bushing
Axle Bracket Bushing
Removal
1. Remove the upper suspension arm from the axle.
2. Install the Bushing Remover/Installer 9948 through the bushing and bracket using the following:
