Wrangler 4WD L4-150 2.5L VIN P MFI (1998)
Cruise Control Servo: Service and Repair
REMOVAL
1. Disconnect negative battery cable at battery
Speed Control Servo Location
2. Disconnect vacuum line at servo.
3. Disconnect electrical connector at servo.
4. Disconnect servo cable at throttle body. Refer to Servo Cable Replacement.
Servo Cable Clip Remove/Install - Typical
5. Remove 2 mounting nuts holding servo cable sleeve to bracket.
6. Pull speed control cable sleeve and servo away from servo mounting bracket to expose cable retaining clip and remove clip.
NOTE: The servo mounting bracket displayed is a typical bracket and may/may not be applicable to this model vehicle.
7. Remove servo from mounting bracket.
INSTALLATION
1. Position servo to mounting bracket.
2. Align hole in cable connector with hole in servo pin. Install cable-to-servo retaining clip.
3. Insert servo mounting studs through holes in servo mounting bracket.
4. Install servo mounting nuts and tighten to 8.5 N.m (75 in. lbs.).
5. Connect vacuum line at servo.
6. Connect electrical connector at servo.
7. Connect servo cable to throttle body Refer to Servo Cable Replacement.