Wrangler 4WD L4-150 2.5L VIN P MFI (1998)
Check Pinion Gear Rotating Torque
15. Slowly tighten the nut in 6.8 Nm (5 ft. lbs.) increments until the rotating torque is achieved. Measure the rotating torque frequently to avoid over
crushing the collapsible spacer.
16. Check bearing rotating torque with a (inch lbs.) torque wrench. The torque necessary to rotate the pinion gear should be:
-
Original Bearings - 1 to 3 Nm (10 to 20 inch lbs.).
-
New Bearings - 2 to 5 Nm (15 to 35 inch lbs.).
17. Install differential in housing.