Wrangler 4WD V6-3.8L (2009)
Door Lock Cylinder: Service and Repair
Front Full Door Lock Cylinder - Installation
INSTALLATION
1. Assemble the gasket (1) onto the lock cylinder (2), until fully seated.
2. Install the lock cylinder (2) into the hole in the outer door panel.
NOTE: The cylinder post must point forward.
NOTE: The cylinder drain hole must point down.
3. While holding the lock cylinder (2) in place, slide the retainer clip (3) onto the lock cylinder.
NOTE: Visually verify that the pin on the lock cylinder is engaged with the bell crank on the door module, at door module install.
4. Install the carrier plate.See: Doors, Hood and Trunk/Doors/Front Door/Service and Repair/Front Full Door Carrier Plate - Installation.