Workshop Manuals Factory service & repair Land Rover
01 General and service information02 Engine03 Fuel, emissions and engine management04 Cooling system05 Manifolds and exhaust06 Transmission and axles07 Steering and suspension08 Brakes09 Wheels and tyres10 Body, trim and restraints11 Heating and air conditioning12 Electrical and instruments13 Service and recall actions
Land Rover Defender Technical Bulletins12 · Electrical and instruments
12 · Electrical

Stop/tail light-intermittent operation

Make
Land Rover
Model
Defender Technical Bulletins
Section
Stop/tail light-intermittent operation › Stop/tail light-intermittent operation
Electrical and instrumentsStop/tail light-intermittent operation

STOP/TAIL LIGHT-INTERMITTENT OPERATION

Model
Defender
Affected vehicles
All
Date
1997-02-21
Reference
21/02/97
Stop/Tail Light-Intermittent Operation – bulletin page 1

Bulletin text

Stop/Tail Light-Intermittant Operation

MODEL

Defender

DETAIL

Due to poor contact within the rear twin filament bulb holder, the side/brake lights may operate intermittently. A new twin filament bulb holder has been introduced to prevent the bulb holder contacts backing away from the bulb.

ACTION REQUIRED

Upon customer complaint of the side/brake lights becoming inoperative. Prior to replacing a bulb holder, check to ensure that the bulb has not failed. If the bulb filament is intact, the bulb holder should be replaced, the two rear bulb holders should be replaced together.

PARTS INFORMATION

XBP 100190 Twin filament bulb holder

PROCEDURE

Refer to the workshop manual section 86 bulb replacement, or the owners handbook.

© Rover Group 1996

21/02/97

86/05/97/EN

AFFECTED VEHICLES

LP LH LJ LD All

WARRANTY

Normal warranty policy and procedues apply

COMP. CODE

7J3L

SRO

86.40.78 Left hand bulb holder renew 00.10 hour

86.40.78/03 Right hand bulb holder renew 00.10 hour

Parts & tools for this job For Land Rover Defender

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.