Workshop Manuals Factory service & repair Land Rover
01 General and service information02 Engine03 Fuel, emissions and engine management04 Cooling system05 Manifolds and exhaust06 Transmission and axles07 Steering and suspension08 Brakes09 Wheels and tyres10 Body, trim and restraints11 Heating and air conditioning12 Electrical and instruments13 Service and recall actions
Land Rover Defender Technical Bulletins02 · Engine
02 · Engine

4 Cylinder engines-inhibiting operation (ckd)

Make
Land Rover
Model
Defender Technical Bulletins
Section
4 Cylinder engines-inhibiting operation (CKD) › 4 Cylinder engines-inhibiting operation (ckd)
Engine4 Cylinder engines-inhibiting operation (ckd)

4 CYLINDER ENGINES-INHIBITING OPERATION (CKD)

Model
Range Rover Classic Discovery Defender
Affected vehicles
N/A N/A N/A N/A
Date
1996-01-17
Reference
17/01/96
4 Cylinder Engines-Inhibiting Operation (Ckd) – bulletin page 1
4 Cylinder Engines-Inhibiting Operation (Ckd) – bulletin page 2

Bulletin text

4 Cylinder Engines-Inhibiting Operation (CKD

MODEL

Range Rover Classic Discovery Defender

DETAIL

When engines are packed for CKD markets, and service replacement engines, a corrosion inhibitor is applied to all cylinder bores to prevent the onset of corrosion. It is imperative that any excess inhibitor is removed prior to initial cranking to prevent irrepairable damage occurring.

ACTION REQUIRED

Prior to starting any CKD or Replacement engine refer to the procedure detailed below.

PARTS INFORMATION

Not applicable

PROCEDURE

Prior to completing any work on the engine the correct service process should be used when removing spark plugs and injectors refer to section 12 of the work shop manual. It is important that the procedures below are followed before the engine is cranked.

Care should be taken before completing this task

1. Remove fuel injectors or spark plugs from the engine 2. Cover all fuel injectors or spark plugs with a lint free cloth. 3. Crank the engine for approximately 15 seconds, this should be repeated until there are no traces of inhibit fluid discharged from the injector/spark plug holes.

Continued...............................

17/01/96

12/01/96/EN

AFFECTED VEHICLES

LP N/A LH N/A LJ N/A LD N/A

WARRANTY

Normal Warranty policy and procedures apply

COMP. CODE

1A2S

SRO

12.41.89/26 expel corrosion inhibitor 0.80 hour Diesel Derivatives

12.41.89/26 expel corrosion inhibitor 0.35 hour Petrol Derivatives

4 Cylinder Engines-Inhibiting Operation (CKD only)

MODEL

Range Rover Classic Discovery Defender

Sufficient elapsed time between each 15 second crank should be allowed for any residue inhibitor to settle in the cylinder bores.

3. Replace fuel injectors or spark plugs.

4. Start engine.

Cover all injector/spark plug holes with a clean wiper to ensure the discharge is contained. Operators should be wearing protective glasses and adequate safety clothing, ie overalls. Under no circumstances should this task be completed with anyone in close proximity to the engine compartment.

17/01/96 12/01/96/EN

AFFECTED VEHICLES

LP N/A LH N/A LJ N/A LD

Parts & tools for this job For Land Rover Defender

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.