300Tdi Defender
CHASSIS AND BODY
15
REPAIR
Refit
8. Insert glass into runners at an angle as
illustrated.
9. Whilst lifting glass, position it squarely in
runners, raise to top of travel and insert timber
support.
10. Secure hinge side runner with single screw
ensuring that packing strip is in position.
11. Locate packing strip and secure opposite runner
with 2 screws. Ensure that all 3 screw heads are
well below bottom of runners to prevent damage
to glass.
12. Locate regulator in window lift channels.
13. Fit mounting panel
See Mounting panel - front
door .
LOCKING BARREL - FRONT DOOR
Service repair no - 76.37.39
Remove
1. Remove door trim casing
See Door trim
casing and plastic sheet.
2. Remove mounting panel
See Mounting panel
- front panel .
3. Raise and support glass to gain access to latch
mechanism.
4. Release spring clip and disconnect rod from lock
operating lever.
5. Remove single screw and withdraw lock lever
assembly.
6. Withdraw lock barrel from exterior door handle
complete with locking sleeve.