300Tdi Defender Rear Side Door Window Regulator - Chassis and Body Upgrades
CHASSIS AND BODY
3
REPAIR
Refit
7. Remove any trim fasteners held in door panel.
Refit or insert new clips to trim panel.
8. Ensure that anti-vibration pads are in position
and offer-up trim casing to door. Align fasteners
with holes in door and firmly push trim into
position.
9. Fit bezels to locking button and remote control
lever.
10. Fit single screw behind remote control lever.
11. Fit door pull and secure with 2 screws and
finisher caps.
12. Fit window regulator handle and retain with
single screw and finisher.
WINDOW REGULATOR - REAR SIDE DOOR
Service repair no - 76.31.45
Remove
1. Remove door trim casing
See Door trim casing
.
2. Remove plastic sheet.
3. Temporarily fit handle, wind window up to its
fullest extent and support glass with a length of
timber, to prevent it falling when removing
regulator.
4. Remove 4 screws retaining regulator to
mounting panel and withdraw regulator whilst
sliding lifting arm button from lifting channel. To
assist this operation, remove timber and lower
glass.