Defender 90 (LD) V8-4.0L (1997)
Neutral Safety Switch: Service and Repair
Inhibitor Switch
Service Repair No - 44.15.19
Inhibitor Switch
REMOVAL
1. Site vehicle on a four post ramp [hoist].
2. Disconnect battery negative lead. Raise vehicle.
3. Disconnect inhibitor switch multipiug.
4. Remove inhibitor switch retaining plate.
5. Remove inhibitor switch.
6. Remove O-ring seal.
7. Clean inhibitor switch.
INSTALLATION
8. Clean mating face on casing.
9. Install and lubricate NEW O-ring seal to switch.
10. Install switch to casing.
11. Secure with retaining plate and bolt.
12. Connect multiplug to harness.
13. Reconnect battery and remove vehicle from ramp [hoist].