Defender TD5 Brake Servo Assembly
BRAKES
5
REPAIR
SERVO ASSEMBLY
Service repair no - 70.50.01
Remove
Before starting, refer to general brake service
practice. See Adjustment.
NOTE: The non-return valve and grommet
are the only serviceable components. In
event of failure or damage, fit a new unit.
1. Remove master cylinder. See this Section.
2. Release vacuum hose from servo.
3. Disconnect brake light switch Lucars.
4. Remove 3 screws securing closing panel to
lower ’A’ post.
5. Release closing panel sufficient to gain access
to brake pedal return springs.
6. Release 2 brake pedal return springs from brake
pedal.
7. Remove blanking grommets from either side of
pedal box.
8. Remove split pin and clevis pin securing servo
push rod to brake pedal.
9. Remove 2 nuts securing servo to pedal box.
10. Remove servo assembly and rubber washer
from pedal box.