Discovery II
ENGINE - V8
OVERHAUL 12-2-55
Seal - timing gear cover
$% 12.65.05.01
Disassembly
1. Secure tool LRT-12-080 to crankshaft pulley
with 2 bolts.
2. Remove crankshaft pulley bolt.
3. Remove crankshaft pulley.
4. Using tool LRT-12-088, remove oil seal from
timing gear cover and discard.
Reassembly
1. Clean seal register in timing gear cover and
crankshaft pulley.
2. Ensure that bolt holes are clean and dry.
3. Apply smear of Retinax LX grease to seal
running surface on crankshaft.
CAUTION: Replacement oil seal is pre-
greased, do not apply additional lubricant.
4. Fit seal to timing gear cover using tool LRT-12-
089 .
5. Secure tool LRT-12-080 to crankshaft pulley
with 2 bolts. Fit crankshaft pulley.
6. Fit crankshaft pulley bolt and tighten to 270 Nm
(200 lbf.ft).
7. Remove tool LRT-12-080 from crankshaft
pulley.