Discovery II
FRONT SUSPENSION
60-30
REPAIRS
Refit
1. Clean lower ball joint location and surrounding
area of axle yoke.
2. Apply a 12 mm (0.5 in) wide yellow paint stripe
on axle yoke, adjacent to lower ball joint
location.
3. Fit tool LRT-54-022 to tool LRT-54-008 and
secure with screw.
4. Fit tool LRT-54-022 and tool LRT-54-008 to
lower ball joint location on axle yoke.
5. Fit new lower ball joint to tool LRT-54-008/14.
6. Fit LRT-54-008/14 and lower ball joint to LRT-
54-008, with lower ball joint positioned on axle
yoke.
7. Align tool assembly and press lower ball joint
into axle yoke.
CAUTION: Damage to the joint boot will
result if the tool is not correctly aligned
during the fitting procedure.
8. Remove tools from axle yoke
9. Fit steering knuckle.
Steering knuckle
$% 60.15.19
Remove
1. Remove wheel hub.
2. Remove 3 bolts securing mudshield and
remove mudshield.
3. Remove 2 nuts securing track rod and (if
applicable) drag link to steering knuckle.
4. Break taper joints using LRT-57-036, then
position track rod and drag link aside.