Discovery II
MANIFOLDS AND EXHAUST SYSTEMS - V8
REPAIRS 30-2-19
20. Position container to collect spillage.
21. Release clips and disconnect 2 coolant hoses
from throttle housing.
22. Loosen outer cable locknuts and release
throttle and cruise control cables from
abutment.
23. Release throttle and cruise control cables from
clips and throttle cams and position aside.
24. Depress plastic collar and disconnect brake
servo hose from inlet manifold.
25. Release clip and disconnect breather hose
from manifold.
26. Disconnect vacuum hose from manifold.
27. Release engine harness from bulkhead clips
and position aside.
28. Release and remove bonnet seal from rear of
engine bay.
29. Remove 2 bolts securing air pipe and coil
bracket to manifold.
30. Loosen 2 lower bolts securing coil bracket
sufficiently to allow bracket to clear manifold.
31. Release plug leads from upper manifold clips.
32. Loosen clip and disconnect air hose from air
valve.
33. Remove 2 nuts securing RH air manifold
support bracket to upper inlet manifold.