Discovery II
PANEL REPAIRS
REPAIRS 77-2-21
REPAIRS
Front bulkhead assembly
Remove
1. Disconnect both battery leads, negative lead
first.
2. Disconnect leads/multiplug from alternator.
3. Remove front wing.
4. Remove washer reservoir.
Reservoir - washer - up to 03MY.
5. Models with A/C: Remove condensor.
6. Diesel models: Remove gearbox fluid cooler.
7. Remove RH and LH headlamps.
LIGHTING, REPAIRS, Headlamp - up
8. Release headlamp levelling motors and
position aside.
9. Release headlamp wiring and position aside.
10. Remove battery.
11. Remove battery tray.
12. Remove air filter assembly.
Td5, REPAIRS, Air filter assembly.
V8, REPAIRS, Air cleaner assembly.
13. Remove 2 earth leads from LH of front
bulkhead.
14. Remove RH horn.
15. Models with A/C: Release and remove A/C
pipes.
16. Remove RH and LH crush cans.
17. Remove bonnet release cable.
18. Support bonnet in open position
19. Remove bonnet locking mechanism.
20. Remove VIN plate.
21. Remove 2 bolts securing front bulkhead
assembly to chassis.
22. Remove centre braces.
Repair
1. Remove existing panel(s), prepare panel joint
faces and install new panel(s) in accordance
with Panel Replacement Procedure. Punch or
drill holes in new panel for plug welding as
shown.
Refit
1. Fit centre braces.
2. Fit 2 bolts securing bulkhead to chassis and
tighten to 45 Nm (33 lbf.ft).
3. Fit VIN plate.
4. Fit bonnet locking mechanism.
5. Fit bonnet release cable.
6. Fit crush cans.
7. Models with A/C: Fit A/C pipes.
8. Fit RH horn.
9. Fit 2 earth leads to LH of front bulkhead.
10. Fit air filter assembly.
Td5, REPAIRS, Air filter assembly.
V8, REPAIRS, Air cleaner assembly.
11. Fit battery tray.
12. Fit battery. Do not connect leads.
13. Fit headlamp wiring and headlamp levelling
motors.
14. Fit RH and LH headlamps.
LIGHTING, REPAIRS, Headlamp - up
15. Diesel models: Fit gearbox fluid cooler.
16. Models with A/C: Fit condensor.
17. Fit washer reservoir.