Drinks tray replacement

DRINKS TRAY REPLACEMENT

Model

Discovery

Affected vehicles

from 163104 and 501920

Reference

76/22/95/EN

Bulletin text

Drinks Tray Replacement

MODEL

Discovery

DETAIL

If the drinks tray assembly is to be replaced, and the vehicle is fitted with the fog lamp switch, it will be necessary to remove the spring retaining tab from the switch pack aperture . Failure to remove this tab will result in a foul condition with the fog lamp switch.

NOTE: The retaining tab is only removed on the switch panel side

NOTE: As from June 1995 Discovery is produced on two production lines, therefore you will find differing VIN numbers.

ACTION REQUIRED

Should a vehicle require a replacement drinks tray, follow the procedure below.

PARTS INFORMATION

AWR 1200 LNF Drinks tray assembly.

PROCEDURE

1) With the switch pack removed, cut off the spring retaining tab ( as shown in the illustration), as close to the base as possible. 2) Fit the carrier and switches as normal. 3) The switch will be difficult to fit, if insufficient material has been removed.

Note: This process can be carried out with the tray assembly in position.

19/07//95

76/22/95/EN

AFFECTED VEHICLES

LP LH LJ from 163104 and 501920 LD

WARRANTY

Normal warranty policy and procedures apply

COMP. CODE

8Z3C

SRO

76.46.89/28 Remove spring retainer 00.01