Memory upgrade information

MEMORY UPGRADE INFORMATION

Model

New Range Rover Discovery Defender

Affected vehicles

All All All

Date

1996-11-14

Reference

14/11/96

Bulletin text

TestBook Information

Memory Upgrade Information

MODEL

New Range Rover

Discovery Defender

DETAIL

To enable TestBook to handle the planned developments of software for 1997 it is essential to ungrade the memory of all TestBooks to 20MB. This will be carried out by exchanging your existing TestBook for one that has already been upgraded. You will keep the upgraded TestBook, and the old will be returned to Hewlett Packard. This work will be carried out by Hewlett Packard or their appointed agent at a date and time agreed with yourselfs. Some TestBooks may have already been upgraded as part of the normal exchange process, therefore, to establish whether your machine requires the upgrade please refer to the attached procedure.

ACTION REQUIRED

For checking your TestBook - ‘’TestBook Memory Upgrade Check’’. To ensure that your TestBook is upgraded or confirm that it has already been done, would you please complete the attached form and return it to the UK TestBook Help Desk (address information below).

PARTS INFORMATION

Not applicable

PROCEDURE

Please complete the attached ‘’TestBook Memory Upgrade Requirements’’ and retutn to the UK TestBook Help Desk on:

Fax No ** 44-1865 746653

 Rover Group 1996

14/11/96

TB014/96/EN

AFFECTED VEHICLES

LP All LH LJ All LD All

WARRANTY

Not applicable

COMP. CODE

Not applicable

SRO

Not applicable

TestBook Memory Upgrade Check

Your TestBook may have already been upgraded, Please follow the instructions below to determine if your machine requires the upgrade.

1) Behind the screen you will find a label with:

Model Number.

Serial Number

Option

Check the model number,- if model no is 27070 C , then the TestBook will already have been upgraded, no further action is required.

If model number, is 27070 B , please check the following:

1) On or near the above mentioned label, there may be a sticker printed “MEM”. This indicates that the memory upgrade has already been performed and no further action is required.

2) If no “MEM” sticker can be found on a model 27070 B then power up TestBook and watch the message at power-on. You should see a message saying “Please Wait” - below this message will be a number counting up. If this stops at 4096, and the TestBook continues to power on, an upgrade is required.

If, however, the number does not stop at 4096 but continues on to 20,480 - the TestBook already has 20M B of memory and no upgrade is necessary.

If you have any doubts about this procedure please contact the UK TestBook Help Desk:

Tel No. # # 44 (0) 1865 746699

Fax No.# # 44 (0) 1865 746653

Thank you for your co-operation.