300Tdi Discovery
GENERAL SPECIFICATION DATA
1
INFORMATION
ENGINE 3.9 V8i
Type
V8i
.................................................................................
Number of cylinders
Eight, two banks of four
.........................................................
Bore
94,00 mm
.................................................................................
Stroke
71,12 mm
...............................................................................
Capacity
3950 cc
...........................................................................
Compression ratio
8.13:1 or 9.35:1
............................................................
Valve operation
Overhead by push-rod
................................................................
Maximum power
- 8.13:1
127kW at 4550 rev/min
............................
- 9.35:1
134kW at 4750 rev/min
............................
Crankshaft
Main journal diameter
58,409-58,422 mm
.......................................................
Minimum regrind diameter
57,393-57,406 mm
...............................................
Crankpin journal diameter
50,800-50,812 mm
................................................
Minimum regrind diameter
49,784-49,797 mm
...............................................
Crankshaft end thrust/(end float)
Taken on thrust washers of centre main bearing
......................................
0,10-0,20 mm
Main bearings
Number and material
5, Lead-indium
........................................................
Diametrical clearance
0,010-0,048 mm
.......................................................
Undersize bearing shells
0,254 mm, 0,508 mm
..................................................
Connecting rods
Type
Horizontally split big-end, plain small-end
.................................................................................
Length between centres
143,81-143,71 mm
...................................................
Big-end bearings
Type and material
Lead-indium
............................................................
Diametrical clearance
0,015-0,055 mm
.......................................................
End-float crankpin
0,15-0,36mm
............................................................
Undersize bearing shells
0,254 mm, 0,508 mm
..................................................
Piston pins
Length
72,67-72,79 mm
..............................................................................
Diameter
22,215-22,220 mm
..........................................................................
Fit-in connecting rod
Press fit
.........................................................
Clearance in piston
0,002-0,007 mm
..........................................................