300Tdi Discovery
MAINTENANCE
9
MAINTENANCE
CHECK CONDITION OF DRIVE BELT - V8i - Tdi -
Mpi
RENEW - V8i - Tdi
Renew drive belt V8i.
See ENGINE, Repair, Drive
Belt Renew
Renew drive belt Tdi.
See ENGINE, Repair, Drive
Belt Renew
RENEW - Mpi
1. Check condition of drive belt, renew a belt that
shows signs of wear, splitting or oil
contamination.
2. Check belt length indicator, belt must be
renewed before indicator reaches R.H. end of
slot.
3. Use 15mm ring wrench on bolt and hold
tensioner pulley fully clockwise.
4. Release drive belt from tensioner pulley and
remove ring wrench.
5. Remove belt from between pulleys.
6. Clean drive belt pulley grooves and ensure
grooves are not damaged.
7. Fit new drive belt around pulley, except
tensioner pulley, ensuring all grooves are
correctly engaged.
8. Hold tensioner pulley fully clockwise and fit drive
centrally around tensioner pulley.
RENEW ANCILLARY DRIVE BELTS
CHECK/TOP UP AUTOMATIC TRANSMISSION
FLUID LEVEL
NOTE: Transmission fluid level is checked
when fluid is cold with engine idling in
neutral.
1. Ensure vehicle is on level ground.
2. Check fluid level registers between MAX and
MIN marking on dipstick.