300Tdi Discovery
Mpi
13
REPAIR
19. Connect crankshaft sensor, knock sensor, air
conditioning compressor, fuel injector harness,
inlet manifold air temperature and fuel
temperature sensor multiplugs.
20. Connect fuel hose to pressure regulator and
secure with clip.
21. Fit and tighten fuel pipe to fuel rail union.
22. Connect multiplugs to throttle housing.
23. Connect vacuum hose to manifold.
24. Connect oil pressure switch multiplug.
25. Connect brake servo hose to manifold, secure
with clip.
26. Connect throttle cable to cam.
27. Position engine harness and connect breather
hose to inlet manifold, secure with clip.
28. Connect coolant temperature sensor multiplugs,
secure harness with cable tie.
29. Connect oxygen sensor multiplug, secure
harness with cable tie.
30. Connect alternator harness.
31. Connect heater hose to heater rail and secure
with clip.
32. Connect hose to coolant pump and secure with
clip.
33. Connect inlet hose to power steering pump and
secure with clip.
34. Fit and tighten outlet pipe union to power
steering pump.
35. Connect bypass and top hose, secure with clip.
36. Connect air cleaner to throttle housing hose and
secure with clip.
37. Remove engine lifting bracket.
38. Position spark plug cover and secure with
screws.
39. Fill engine with oil.
40. Fit bonnet [hood].
See CHASSIS AND BODY,
Repair, Bonnet [Hood]
41. Fit radiator.
See COOLING SYSTEM, Repair,
Radiator - Mpi
42. Adjust throttle cable.
See FUEL SYSTEM,
Adjustment, Throttle Cable Adjustment
ENGINE SUMP GASKET
Service repair no - 12.60.43
Remove
1. Drain engine oil.
2. Refit drain plug, use new sealing washer if
necessary, tighten to the correct torque.
3. Remove 18 bolts securing sump.
NOTE: 25mm long bolt is fitted at rear L.H.
corner of sump.
4. Release sump from cylinder block.
5. Discard gasket.
