300Tdi Discovery
Tdi
13
REPAIR
OIL SUMP
Service repair no - 12.60.44
Remove
1. Disconnect battery negative lead.
2. Drain engine oil.
3. Slacken sump securing bolts and, using a sharp
knife, break sealant around sump flange.
4. Remove bolts and withdraw sump.
Refit
5. Clean mating faces of sump, timing gear housing
and cylinder block.
6. Apply a 2,0 mm bead of ’Hylosil RTV102’ to the
sump flange, ensuring bead is applied inboard of
the bolt holes.
7. Secure sump to block with bolts. Tighten to
25
Nm.
8. Refill engine oil.
See LUBRICANTS, FLUIDS
AND CAPACITIES, Information,
Recommended Lubricants and Fluids
9. Reconnect battery negative lead.
OIL PICK-UP STRAINER
Service repair no - 12.60.20
Remove
1. Disconnect battery negative lead.
2. Drain engine oil.
3. Remove engine oil sump.
See Oil Sump
4. Remove bolts securing pipe support bracket.
5. Remove bolts from pipe flanges.
6. Withdraw pick-up strainer assembly.
Refit
7. Refit pick-up strainer assembly, fitting a new ’O’
ring seal at oil pump connection.
8. Apply Loctite 242E to the two screws at the
bearing cap. Tighten to
9 Nm.
9. Fit bolts to pipe flanges. Tighten to
25 Nm.
10. Refit engine oil sump.
See Oil Sump
11. Reconnect battery negative lead.