300Tdi Discovery
Mpi
3
REPAIR
FUEL TEMPERATURE SENSOR
Service repair no - 18.30.08
Remove
1. Disconnect fuel temperature sensor multiplug.
2. Remove fuel temperature sensor.
3. Discard sealing washer.
Refit
4. Clean mating face of fuel rail.
5. Fit a new sealing washer to sensor.
6. Fit temperature sensor. Tighten to
7 Nm
7. Connect fuel temperature sensor multiplug.
MEMS ENGINE CONTROL MODULE (ECM)
Service repair no - 18.30.01
Remove
1. Remove 3 bolts securing ECM.
2. Disconnect 2 multiplugs from ECM.
3. Disconnect vacuum hose from ECM.
4. Remove ECM.
5. Collect ECM spacers (LHD only)
Refit
6. Position ECM and spacers to wing [fender].
7. Connect vacuum hose to ECM.
8. Connect multiplugs to ECM.
9. Position ECM to mounting.
10. Fit bolts and tighten.