300Tdi Discovery Rear Axle and Final Drive Torque Specifications
REAR AXLE AND FINAL DRIVE
1
SPECIFICATIONS, TORQUE
AXLE DIFFERENTIAL DATA
Pinion bearing pre-load:
(new bearings)
3 Nm
........................................................
(bearings bedded in)
1,5 Nm
...............................................
Crown wheel run-out
0,10 mm
........................................................
Crown wheel/pinion backlash
0,10 to 0,17 mm
...........................................
REAR HUB
Rear hub end float
0,010 mm
............................................................
TORQUE VALUES
NOTE: Torque wrenches should be regularly checked for accuracy to ensure that all fixings are
tightened to the correct torque.
Nm
REAR AXLE
Pinion housing to axle case
41
.......................................................................
Crown wheel to differential case
58
................................................................
Differential bearing cap to pinion housing
90
..................................................
Differential drive flange to drive shaft
47
.........................................................
Bevel pinion nut
129
........................................................................................
Lower link to axle
176
......................................................................................
Pivot bracket ball joint to axle
176
...................................................................
REAR HUB ABS VEHICLES
Hub driving member to hub
65 *
.......................................................................
Brake disc to hub
73 *
......................................................................................
Stub axle rear to axle case
65
........................................................................
Brake caliper to axle case
82
..........................................................................
Disc shield to axle case
11
.............................................................................
Sensor ring to brake disc ABS
9
....................................................................
* Apply loctite 270 prior to assembly.