300Tdi Discovery
FRONT SUSPENSION
5
REPAIR
ANTI-ROLL[SWAY] BAR ASSEMBLY FRONT
Service repair no - 60.10.01
KEY
1. Anti-roll[sway] bar
2. Rubber bush
3. Strap
4. Nut, bolt, washer
5. Nut and washer
6. Castellated nut and cotter pin
7. Ball joint link arm
Remove
1. Mark for reassembly position of rubber bushes
on anti- roll[sway] bar.
2. Remove four nuts, bolts and washers securing
two bush straps.
3. Remove nuts, bolts, washers and rubber bushes
from ball joint links and remove anti-roll[sway]
bar.
Refit
4. Position bushes on anti-roll[sway] bar. Ensure
split points towards axle on RH bush and away
from axle on LH bush.
5. Fit anti-roll[sway] bar with two straps. To ensure
correct fit angled sides of bar should point down
as shown. Loosely fit the bolts, washers and
nyloc nuts.
6. Fit bolt, washers and rubber bushes. Using new
nuts fit anti-roll[sway] bar to ball joint links.
Tighten to
68Nm.
7. Tighten nuts securing straps to
30Nm