300Tdi Discovery
SUPPLEMENTARY RESTRAINT SYSTEM
1
FAULT DIAGNOSIS
CRASH SENSOR INSPECTION - DISTRIBUTED
SRS
1. After any degree of front body damage, inspect
both front crash sensors. Replace a sensor if
there are any signs of dents, cracks or
deformation.
2. Ensure the sensors are installed correctly. There
must be no gap between the sensor and body of
the vehicle. Use the fixing screws supplied with
the sensor and tighten to the correct torque.
Tighten front sensor fixing before rear sensor
fixing.
CAUTION: Take extra care when painting
or doing body work in the vicinity of the
sensors. Avoid direct exposure of the
sensors or harness to heat guns, welding or
spraying equipment.
AIRBAG HARNESS
1. Never attempt to modify, splice or repair the
airbag harness. Never install electronic
equipment such as; a mobile telephone, two-way
radio or in-car entertainment system in such a
way that it interferes electrically with the airbag
harness.
NOTE: The airbag harness can be
identified by a special yellow outer
protective covering.
2. Make sure the airbag harness is installed
correctly and not pinched or trapped.
3. Ensure all airbag harness connectors are mated
correctly and securely fastened. Do not leave the
connectors hanging loose.